Clear Vision™ Camera - Setup Guide
User Manual
1. Turn switch to OFF
2. Insert AA batteries.
3. Ensure you have the adequate storage space on your MicroSD card for your trail camera videos and photos.
4. Insert you MicroSD card (up to 32 GB).
4. Insert you MicroSD card (up to 32 GB).
5. Turn the power switch ON.
6. Close and secure the latch.
7. The LED Light should flash RED three times. The flashing of the LED Lights indicates that the camera is on and in PIR (Passive Infrared Sensor) status is on (aka Motion Sensor) is on and waiting to be triggered by movement. If no motion is detected PIR mode will go into standby mode until motion is detected.
